Jump to content
Site Restoration Read more... ×
 
AeroPrecision

Recommended Posts

I don't remember where I saw this, but it's interesting.  Displayed at the USAF Museum.  Check out the rank of the first FE.

B-66 FE.jpg

  • Like 1

Share this post


Link to post
Share on other sites

An A/3c fe?  Hard pressed to understand what fe inflight duties there were on a twin engine light bomber.  And what the qualifications were that allowed a rookie one striper just out of tech school to qualify.  Guessing the position more resembling a flying crch. 

When I was an A/3c about all I was allowed to do was empty the relief can and wipe down the engine exhaust paths.  After advancement to A/2c was then permitted to clean the windscreen and wipe down the struts.  

Share this post


Link to post
Share on other sites

Hmmm...I know Wikapedia isn't necessarily the gospel in every case; but...

Design and development

At first, the United States Air Force intended the conversion to be an easy matter of removing the carrier-specific features, so no prototypes were ordered, just five pre-production RB-66A models (the reconnaissance mission being considered a high priority). The list of modifications grew, and before long, the supposedly easy conversion became what was substantially a new aircraft. Many of the changes were due to the USAF's requirement for low-level operations, while the Navy version had originally been designed and employed as a high-altitude nuclear strike bomber. Two major differences between the A-3 and the B-66 consisted in the types of jet engines used, and the emergency crew escape systems. The A-3 had two J57 turbojet engines, whereas the B-66 had two Allison J71s. The B-66 was equipped with ejection seats whereas the A-3 was not.

The first RB-66A pre-production aircraft flew in 1954, whereas the first production RB-66B aircraft flew in the beginning of 1955.

The basic B-66 design proved to be a versatile one, and was produced or modified into a variety of other versions, including the EB-66, RB-66, and the WB-66. Likewise, many variants of the A-3 Skywarrior were produced.

Operational history

220px-Douglas_RB-66B_54-506_19_TRS_Scul_
 
RB-66B of 19 Tactical Reconnaissance Squadron based at RAF Sculthorpe England in 1957

Deliveries to the Air Force began in 1956, with 145 of this model produced. RB-66s were used as the primary night photo-reconnaissance aircraft of the USAF during this time, many examples serving with tactical reconnaissance squadrons based in the United Kingdom and in West Germany. A total of 72 of the B-66B bomber version were built, 69 fewer than originally planned. A total of 13 B-66B aircraft later were modified into EB-66B electronic countermeasures (ECM) aircraft for the cold war with Russia, and were stationed at RAF Chelveston with the 42nd Tactical Reconnaissance Squadron who did the conversion in the early 1960s. They would rotate out of an alert pad in Spain during the time that the 42nd had them. These and the RB-66Cs that the 42nd had would eventually be sent to Vietnam. Unlike the U.S. Navy's A-3 Skywarrior, which performed some bombing missions, the Destroyer was not used as a bomber in Vietnam.

Specifications (B-66)

General characteristics

 

One of the guys in my first ops duty in Thailand had been in B-66 bomb-droppers in France earlier in his career. He wasn't an EWO. Makes me wonder if the crew make-up was pilot, nav-bomb, and EWO in the bombers. For sure there wouild have been an EWO in the EB's. I suspect that this post is bs of somekind. No FE in B-47 or B-52. "Unlike...the Destroyer was not used as a bomber in Vietnam..." according to Wikapedia.

Share this post


Link to post
Share on other sites
On 8/2/2018 at 11:03 AM, larry myers said:

An A/3c fe?    Guessing the position more resembling a flying crch

 

Yep, Larry, that was my first thought -- a flying crch, but all the B-66's at Korat took off and landed back at the same base.  Also, these planes were flying over North Vietnam.  Don't think they'd allow a crew chief to tag along.

When you mentioned your duties as an A/3C, you omitted the wash rack.  Spent a lot of time washing the bellies of a lot of B-models.

Don R.

  • Like 1

Share this post


Link to post
Share on other sites

Don,  I think you've hit the nail on the head.  I agree, no way would a non-essential person be allowed to fly on an aircraft entering hostile territory.  Further, as you said, the fact the aircraft took off, flew the sortie and landed back at home base lends further credence to your statement.  Guessing there was something peculiar going on in the outfit that caused senior leadership to decide a flt. eng. was necessary.

My first five years were in a B-47E wing.  The last three years were as a crew chief.  Strange thing I don't remember ever washing my aircraft.  And don't remember where the wash rack was.  In my defense, I don't remember what I had for lunch.  However, my next three assignments I vividly remember washing mine and other acft. … repeatedly.  By the time I got to CCK thankfully had been promoted out of the wash rack crew.  The 374th was doing it the smart way...by contractor.   

The one thing I remember well that you didn't mention was KP.  The worst ass chewing I ever got was by the mess sergeant.  Seems I left the potatoes in the peeler too long and they came out the size of golf balls.  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×