MR RELIABLE

YOU MUST CHECK COLLAR BOLTS HOLES FOR ELONGATION BY REMOVING THE ELEVATOR AND NUTS OF BOLTS INSIDE THE TUBE IF HOLES ARE NOT ELONGATED REPLACE NUTS AND ITS A GOOD TO GO OTHERWISE USE HIGHER SIZE HIGH LOCKS INSTEAD OF SCREWS 5/16 INCH I THINK  THIS CHECK IS ALSO PART OF MINOR ISOCHRONIC INSPECTIONS

THIS IS PART OF BLIND NUT ASSEMBLY PART NO BN356-624-15 BUT DOES ANYONE KNOW ITS OWN PART NUMBER AS SINGLE PEICE I AM TIRED OF WASTING WHOLE ASSEMBLY TO GET THIS SINGLE NUT

hello seniors

i want to inquire about part number of blind nuts shown in pictures these are used on dual rail in chine plate at both sides of cargo floor

to.bmp

check for torque strut worn out lower bushings too if problem dont repeat on ground i am 95% sure excessive play is there

IT SEEMs you have shoe rigging error have you evaluated on jacks?