Shola Posted July 7, 2019 Share Posted July 7, 2019 GTCP85-180L starts and run well. However, no bleed air from the APU. Load control valve replaced with new one but no change. In addition, APU doesn't shut down normally unless by the pull of fire handle. Any help please? Quote Link to comment Share on other sites More sharing options...
Shola Posted July 8, 2019 Author Share Posted July 8, 2019 17 hours ago, Shola said: GTCP85-180L starts and run well. However, no bleed air from the APU. Load control valve replaced with new one but no change. In addition, APU doesn't shut down normally unless by the pull of fire handle. Any help please? Aircraft type is C130H. Quote Link to comment Share on other sites More sharing options...
PauloFerreira Posted July 8, 2019 Share Posted July 8, 2019 On 7/7/2019 at 12:30 PM, Shola said: GTCP85-180L starts and run well. However, no bleed air from the APU. Load control valve replaced with new one but no change. In addition, APU doesn't shut down normally unless by the pull of fire handle. Any help please? Hi ! Did you checked the Overspeed Solenoide, Valve? Did you preformed the continuity checks on both electrical plugs (on Load Valve and Solenoid Valve)? The Filter Between the Load Valve and the Solenoid Valve is clean and Tightened? Just some questions and some leads! Kindest Regards!! Quote Link to comment Share on other sites More sharing options...
NATOPS1 Posted July 26, 2019 Share Posted July 26, 2019 Has three speed switch been changed? The 95% arms the bleed air ( does the on speed light illuminate?) and the 110%switch shuts down the APU. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.