C-130 Technical
1,312 topics in this forum
-
Talon II CG
by Hush- 3 replies
- 2.6k views
Quick question - Can anyone recall what the C/G was/is for a Talon II (zero fuel, zero cargo). Thanks- Hush
Last reply by 1685FCC, -
-
- 5 replies
- 3.6k views
Hi guys I got a problem I need your thoughts with. Recently one of our birds twice turned back after oil temperature exceeded +-90°C at altitude. History: The aircraft just completed ISO, and post-dock runs had oil temps getting up to 100°C at ground idle. OAT was in mid 40\'s. Two different oil coolers were fitted, and oil tank was drained and serviced with new oil. After this it was released. The next mission off base the in-flight problem occurred, and the engine was removed for test cell evaluation. In the Cell I started by draining all the oil from tank, RGB, ADH, oil cooler, and motoring the engine to empty all the oil hoses and tubes, and changed all …
Last reply by HerkPFE, -
hi to u all in the -6 v have a chapter who deal with special inspection v got a new guy in the quality ensurens and he want as to do some sp inspection even if its a day by day fault any comment
Last reply by talons1555, -
- 32 replies
- 14.9k views
After all these years, the subject of prop servicing is still discussed. I have experimented the last couple days with propeller oil levels, both static over-night cold level checks and cycled prop pressure sump and atmospheric dipstick checks. One aircraft leaned when I checked it and then I checked it again after I leveled it. What I found out was that the pump housing all act differently when the feather pump motor shuts off. Some drain back immediately and others don\'t drain back at all. A leaning aircraft throws the measurements off. I also found that if left for an additional 24 hours, the levels in both sumps increase. The amount draining back into the …
Last reply by Steve1300, -
- 26 replies
- 17.1k views
Does anyone know the history of the electric valve housings program? We are currently de-modding a bird back to traditional valve housings, and I am interested in the operational history of this program. I understand that there are about 5 birds with this system. I ran this one when it got here, and it ran great. 100% across the board, rock solid. I understand that parts support, troubleshooting/training were factors leading the EPCS\'s demise. The removed components are being \'green tagged\', but I have heard that they are bound for DRMO. Hard to believe...these babies can\'t be cheap.
Last reply by F.Z.N, -
Accoustical Beacon
by Guest- 1 reply
- 2.3k views
Does anybody have a good source for DK120 beacon batteries?
Last reply by Shadoif, -
- 7 replies
- 4.4k views
Have a prop on a -16 that will not pitchlock. Prior to us getting the plane for ballistic foam install, the squadron had the same problem. They changed pitchlock reg., valve housing, then the gearbox sh*t the bed and the prop was seized on the shaft so they r2\'d the tq meter, gearbox, prop/dome. Sooo. They had a good pitchlock after all of that...once...so it could get here. We have tried all manner and techniques IAW pubs, and otherwise without success. It will overspeed without a problem, but does not even think about locking. Re-Indexed about 6 times (1x=2 then 3 master). Tried getting low/ref tq at about 97% then going to 1077 before locking and hitting g…
Last reply by Lkuest, -
NVG Compatible Glass
by Guest- 10 replies
- 4.9k views
I know that some, perhaps all of the MC-130E\'s had new windshields installed for improved compatibility with Night Vision Goggles (NVGs). The original glass for the E models had transmissivity losses in the light spectrum of the NVGs. Does anybody know how many other platforms have been modified; and is NVG compatible glass available from Lockheed as part of the build for the J-models? John